The reassembly buffer must be reset to its origin at the beginning of every
transaction. prov_msg_recv() pulls the PDU type byte (advancing buf->data by
one) and nothing restores it between transactions. Without this reset,
buf->data drifts forward by one byte per received PDU, causing the segment-0
memcpy to write past the end of the statically allocated rx buffer
(PROV_RX_BUF_SIZE), and the XACT_SEG_DATA() offsets used for continuation
segments to be skewed by the accumulated drift.
Fix multiple wire-format and robustness issues in the DFD client
(dfd_cli.c):
- handle_capabilities: read oob_retrieval_supported as u8 instead of
le32. The server encodes a single byte; le32 over-consumed 3 bytes
of the URL scheme list and could over-read the buffer.
- handle_upload_status: extract upload_progress from bits 0-6 (& 0x7F)
and upload_type from bit 7 (>> 7), matching the server encoding
(progress | BIT(7)). The previous >>1 / &0x01 returned wrong values,
mis-classified in-band vs OOB, and falsely rejected valid OOB
messages with high progress.
- handle_dfd_status: correct the transfer-mode byte layout to
trans_mode bits 0-1, update_policy bit 2, RFU bits 3-7 (previously
read bits 6-7 / 5), and fix the RFU mask to 0xF8. Now matches the
struct bitfield definition and the DFD server.
- handle_dfd_status: report status+phase and return early when
buf->len == 0 (IDLE phase) instead of pulling 10 absent bytes.
- bt_mesh_dfd_cli_distribution_start: encode trans_mode/update_policy
into bits 0-2 so the server decodes them correctly.
- handle_receiver_list: validate buf->len >= entries_cnt * 5 before
the loop, and handle entries_cnt == 0 without relying on calloc(0).
- handle_receiver_status: pass the status value (not the whole union)
to the %d log format, fixing undefined behavior.
- dfd_client_recv_status: drop the dead BLE_MESH_DFD_OP_CAPABILITIES_GET
case (a client-send opcode) from the receive switch.
- bt_mesh_dfd_cli_receivers_add: widen msg_length to uint32_t to avoid
uint16_t overflow that bypassed the PDU size guard; add a NULL check
for the receivers array.
- bt_mesh_dfd_cli_distribution_upload_oob_start: return -EINVAL
instead of -1 for consistency with the rest of the file.
The protocol may still receive DFU-related packets from the
network (such as forwarded or retransmitted ones) after DFU ends,
while the user might release the targets immediately after DFU completion.
However, since the list head is not empty, the protocol could access
already-freed memory when iterating through the targets.
- Fix DFU server transfer error state ordering to ensure proper callback delivery
- Add validation to discard chunks when blob server is not in busy state
- Prevent chunk processing when server is not in active transfer state
Jiang Jiang Jian
luoxu
zhiweijian
ShenWeilong
Island
Linyan Liu
Ashish Sharma