Merge branch 'feat/spi_std_timing_and_bit_trans_v5.3' into 'release/v5.3'

feat(driver_spi): support adjust master rx to standard timing (v5.3)

See merge request espressif/esp-idf!36400

components/esp_driver_spi/include/driver/spi_master.h

@@ -78,6 +78,7 @@ typedef struct {
         delay before the MISO is ready on the line. Leave at 0 unless you know you need a delay. For better timing
         performance at high frequency (over 8MHz), it's suggest to have the right value.
         */
+    spi_sampling_point_t sample_point;  ///< Sample point tuning of spi master receiving bit.
     int spics_io_num;               ///< CS GPIO pin for this device, or -1 if not used
     uint32_t flags;                 ///< Bitwise OR of SPI_DEVICE_* flags
     int queue_size;                 ///< Transaction queue size. This sets how many transactions can be 'in the air' (queued using spi_device_queue_trans but not yet finished using spi_device_get_trans_result) at the same time

components/esp_driver_spi/src/gpspi/spi_master.c

@@ -475,6 +475,10 @@ esp_err_t spi_bus_add_device(spi_host_device_t host_id, const spi_device_interfa
     SPI_CHECK(ret == ESP_OK, "assigned clock speed not supported", ret);
     temp_timing_conf.clock_source = clk_src;
     temp_timing_conf.source_pre_div = clock_source_div;
+    temp_timing_conf.rx_sample_point = dev_config->sample_point;
+    if (temp_timing_conf.rx_sample_point == SPI_SAMPLING_POINT_PHASE_1) {
+        SPI_CHECK(spi_ll_master_is_rx_std_sample_supported(), "SPI_SAMPLING_POINT_PHASE_1 is not supported on this chip", ESP_ERR_NOT_SUPPORTED);
+    }
 
     //Allocate memory for device
     dev = malloc(sizeof(spi_device_t));